Re: Bench test wiring to start engine.
I would like to continue with this thread because I have the same goals.
OK: - new coil
- 12v from batt connected.
- points and condenser look new.
- new batt.
- truck turns over easily with compression but no fire at the plug level.
- plugs look almost new.
- wires look like they should work fine.
- I don't have key for ignition
I'm thinking I need to check the point gap. Anything I'm not thinking about??
Gas line is disconnected and I'm using ether just to get a "pop"
Thanks for the help!!!
__________________
It's Not Rust, It's Patina!!
1967 C 20 Large Window, 700R4, 283, Tilt, PS, PB.....A Rusty But Trusty Gas Hog
2008 Silverado LTZ 1500 4x4
|