The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - "Project S" - My boy Sam's '72 2wd Blazer -The Red Sled

skorpioskorpio · 05-21-2013, 01:19 PM

Just so you are aware, seems the guys who have had those sliding tops done with vinyl have been far less happy with them than those that have had them done in canvas. Now most of this is old reviews from when these were mainly sold through Street Beat Customs, but still, I'd quiz Rick on that.

What size are you going for? I measured out the inset on the inside of the double wall at about 50x80 if I remember correctly. Are you planning to go all the way out to the inset size? This was my plan. I think that makes it like 2" larger than that for the outside hole and again 2" larger than that for the fabric, or something like that.

05-21-2013, 01:19 PM	#98
skorpioskorpio Registered User Join Date: Nov 2010 Location: Los Angeles, CA Posts: 1,018	Re: "Project S" - My boy Sam's '72 2wd Blazer -The Red Sled Just so you are aware, seems the guys who have had those sliding tops done with vinyl have been far less happy with them than those that have had them done in canvas. Now most of this is old reviews from when these were mainly sold through Street Beat Customs, but still, I'd quiz Rick on that. What size are you going for? I measured out the inset on the inside of the double wall at about 50x80 if I remember correctly. Are you planning to go all the way out to the inset size? This was my plan. I think that makes it like 2" larger than that for the outside hole and again 2" larger than that for the fabric, or something like that.