The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

MiraclePieCo · 02-14-2018, 05:18 PM

Okay, I'm not going Harvey Weinstein on you, I just need help identifying this pinion yoke so I can get u-joints and make a driveshaft. It's a GM 12-bolt but the pinion yoke seems non-standard. Those cups are 1-1/16" but that's supposed to be an outside clip u-joint but there are no retaining tabs. My local driveline guy suspects someone ground off the retaining tabs. I'm much more familiar with Ford rear ends; any classic Chevy guys help me out?

02-14-2018, 05:18 PM	#1
MiraclePieCo Registered User Join Date: Sep 2014 Location: USA Posts: 2,249	Pictures of my rear end Okay, I'm not going Harvey Weinstein on you, I just need help identifying this pinion yoke so I can get u-joints and make a driveshaft. It's a GM 12-bolt but the pinion yoke seems non-standard. Those cups are 1-1/16" but that's supposed to be an outside clip u-joint but there are no retaining tabs. My local driveline guy suspects someone ground off the retaining tabs. I'm much more familiar with Ford rear ends; any classic Chevy guys help me out? Attached Images Last edited by MiraclePieCo; 02-15-2018 at 04:26 AM.