The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - A MUST HAVE cheapie spray gun for using upside down.

MARTINSR · 08-04-2018, 10:59 PM

All I simply did was removed the cup from the gun, and screwed onto that fitting a female connector for a hose.
I then got a quart can and drilled a hole through it for a male fitting for a hose. I made a gasket out of rubber and put a large flat washer on the fitting, put a nut on the back and tightened it up good so it wouldn't leak.

I made a funky little bracket tied to the can with a hose clamp. Then screwed that to the dash where the windshield moulding screw hole.

Brian

08-04-2018, 10:59 PM	#15
MARTINSR Registered User Join Date: Dec 2000 Location: Boise, Idaho Posts: 6,001	Re: A MUST HAVE cheapie spray gun for using upside down. All I simply did was removed the cup from the gun, and screwed onto that fitting a female connector for a hose. I then got a quart can and drilled a hole through it for a male fitting for a hose. I made a gasket out of rubber and put a large flat washer on the fitting, put a nut on the back and tightened it up good so it wouldn't leak. I made a funky little bracket tied to the can with a hose clamp. Then screwed that to the dash where the windshield moulding screw hole. Brian Attached Images __________________ 1948 Chevy pickup Chopped, Sectioned, 1953 Corvette 235 powered. Once was even 401 Buick mid engined with the carburetor right between the seats! Bought with paper route money in 1973 when I was 15. "Fan of most anything that moves human beings"