Re: Gen 3 Drive By Wire cruise control HOW TO
Well....the drama continues.
I did (correct the brake light switch wiring) you were correct on it was wired wrong. so after this I did start to rewire things like your drawing and all was going fine until I hook up the brown wire from the DD switch (Cruise on) to the factory Grey (cruise on) and the darn orange light comes on. So at this point I removed all wiring from the switch and bench tested the switch power wired up grounds hooked up it works correctly until I try and check for voltage at the yellow (resume pressed I get 12v) same for green (set/coast I get 12v) then check for voltage at the brown wire (cruise on) and I get nothing when I press "on"
Per Brian @ DD he claims the switch is good, and feels there is something wrong at the (cruise on grey wire) from the factory harness??
I am sooo damn confused and angry right now trying to get this set up for this weekend for a road trip and have spent way too much time on this.
I would post a pic of the wiring I had planned but didn't take a pic.
Any advice at this point would be great
Mark
|