View Single Post
Old 04-02-2018, 02:57 PM   #224
68Timber
I know the pieces fit
 
68Timber's Avatar
 
Join Date: Nov 2007
Location: MONTGOMERY, AL
Posts: 5,523
Re: Sarge's rattle-can rebuild

I made a little time for the truck this weekend, but not much picture-worthy. I got the last of the extra brackets cut off the floor and ground smooth and vacuumed all the dirt and mess out. Oddly enough, this was the only piece of civilian floor trim in truck. For all the other stuff that gets deleted it's kinda odd this piece is there. The screws were stuck but a 3/8" manual impact driver did the trick. Good thing it was there, that would have been an odd piece to track down. I thought I had the trim pieces rounded up but I've gotta find the chrome bezels that trim out the floor latches for the passenger front seat and rear bench seat. I got started on the rust in front. This is the passenger side foot well.
Attached Images
  
__________________
John

79 2wd Blazer (Bruiser)
85 M1009 Blazer (Sarge) build
74 Honda Z50 build
68Timber is offline   Reply With Quote