Quote:
Originally Posted by Bearhawg
OK, I'm going to give this one last try. Does anyone have a picture of how the pressure line routes into the rear of the pump? The only thing I can figure is that my current line is not correct for my application but fits because of the way its routed. Any new line will not rout in the same way so I'm trying to determine the factory correct routing.
It's a tough area to just snap a picture so maybe someone has a photo from a previous build?
Thanks!
|
I went through the same thing with my 72 big block truck. not sure if this is the same setup as yours. I had my new line custom made at a local shop. I can get the part numbers on the fittings if necessary. Here is how it was when I got the truck.