Started to work on my harness, found out there is a late and early version of harness, so my TPS and IAC connecters are wrong, plus location with in connecters. Wiring diagram shows this.
While I was working on the harness, found out I was putting the seal on wrong, so, I cut the tabs shorter, maybe a 1/16" or 1/8" and wrapped the tabs around the wire, then slid the seal on, much easier then trying to crimp the seal, as I would cut the seal. Having the right crimper also made the job easier. I like to pre-crimp with a larger size and then do a final crimp. I may go back and solder.
Also, having the right pin tools, is a must, can't remove without releasing lock on the pins
[url=https://flic.kr/p/26oYwbW]20180423_120857
sorry no pics of late style connecter, as I destroyed it on removal