|
Re: 1972 Blazer CST Frame off Project in NC
Long time since my last update. Been super busy at work, and busy on the more tedious elements of the Blazer build. So, heres an update - and thanks as always to the board for all the advice and help.
I bought my wiring harness from M&H and LOVE it. The schematic/diagram that came with it, the quality of the wires/fuse panel, and tech support are great. So I tackled the rear lights. Took some grinding and adjusting to get them to fit - you'll recall I am using repop rear quarters, so they took a little persuading. Another learning was that there are numerous holes required for the taillight trim ring, but I found a set of billet (stupid expensive) ones that fit into the same holes for the lenses, so I went with those and love the look.
|