[DD1]

Today I woke up at the Crack of Noon, so I did not get as much done as I would like, but I think I have settled on how the Rocker will line up and I'm ready to move forward.

I was trying to figure out how to get the front of the rocker to come out a bit more. It was too far in and touching the door edge when it was open.


Decided to make some relief cuts where the red lines are...


It was still touching so I cut a bit further then pushed down on the rocker.


It's not perfect, but it's not touching the door and it's good enough to bondo.



I cleaned off the paint on the outside of the inner rocker panel and put some rust prevention paint on it leaving off the edge where it will be spot welded.