View Single Post
Old 05-22-2019, 07:54 AM   #1
focusedontheprize
Senior Member
 
focusedontheprize's Avatar
 
Join Date: Feb 2012
Location: CA
Posts: 696
Installing junction box for battery needed connections

I recently rebuild the engine harness in my 1987 Chevrolet V30. My goal is only have one wire running to each terminal on the battery, however with the newer accessories (H4 upgraded headlight harness, HD power window kit upgrade, etc.) I am finding this may be a challenge because all of these accessories are required to draw power from the battery.

I was going to install a Stud Type Plastic Junction Box in the engine compartment to run all these connections there. Is this how people are handling these type of situations?

Any tips or recommendations - I am all ears. Thanks everyone.
__________________
"Dixie" - 1988 Chevrolet V30 CCDRW "3+3" | 7.4L 454 (L19) | TH400 | 4" lift | 36"s

"Lucille" - 1949 Chevrolet 3100 | 292 | T5 | 8.8" | 5" drop | The rebirth of Lucile.. (on hold)
focusedontheprize is offline   Reply With Quote