View Single Post
Old 03-17-2018, 08:21 PM   #16
MiraclePieCo
Registered User
 
MiraclePieCo's Avatar
 
Join Date: Sep 2014
Location: USA
Posts: 2,249
Re: Panel Truck Gas Tank Relocation

I got the filler neck location on my '51 panel truck finalized today. Since the truck body is virtually pristine, I was adamant about not cutting any new holes in the body or fenders. Instead I grudgingly cut a hole in the wooden floor. The filler door wouldn't sync with the wood slats so I added a transition piece below to span across the boards and runners. The Camaro tank inlet is offset an inch to the right, further complicating matters.

To prevent vapor intrusion into the cab the cap is sealed with an o-ring, the tank is vented out the right wheel well, and the plate and filler door are sealed with foam weatherstrip tape. Obviously care will be required to avoid spillage when fueling.
Attached Images
  
MiraclePieCo is offline   Reply With Quote