[BigFrz]

Originally Posted by joedoh

it really will depend on where you put the motor mounts. I use a 4.3 4l60e and the stock s10 rear and a 53" shaft works out for me, but I also move the motor back about 10 inches from stock. if I only moved it back 9, I would need a 54" shaft to fit the same.

also with an 8.8 you will need an adapter/conversion joint. If I were you I would put the engine/trans in, make sure the lowering components are installed, get the weight on the frame and measure center of yoke to center of yoke with the trans yoke sticking out about an inch and a half. that will be your length.

Posted via Mobile Device