Re: 1991 V2500 Suburban
Small update.
First pic shows a PTFE braided line with a regular fitting which is wrong. Solution - ordered regular braided line which fixed the gap problem and is meant for those fittings as PTFE lines takes only PTFE fittings
2nd picture is my corvette regulator moved a little bit further forward and mounted directly in line with the tank feed line basically like an original TBI gas filter
3rd picture is my original 91 350 temp sensor that was turned down to 12mm/1.5 im pretty sure, then you take out the pipe plug in the back of the passenger side cylinder and and install it there
4th picture is the temp sensor installed
I also put the driver side fender on because its getting wired this weekend and the battery is on that side which is where I am putting the computer as well basically like the stock gm setup hopefully it runs by the 13th for the truck pull or even better the 20th for an awesome party
Currently it needs coolant, oil and filter and temporary block off plate, air intake assembly which im using from my 2003 temporarily, fender and hood put back on, front driveshaft installed, new rear drive shaft, wired, tuned, gas cap, and probably some other stuff that i'll find out the hard way
Last edited by Mr. 250r; 10-04-2012 at 04:01 AM.
|