View Single Post
Old 08-12-2014, 08:00 PM   #69
clinebarger
Senior Member
 
Join Date: May 2009
Location: Fort Worth, TX
Posts: 6,370
Re: 700R4 build thread.

**If your reusing the Reaction shaft (with a Flat bottom), Place the Brass 4 tang thrust washer on the SunShell, Use TransJel to stick it to the Shell.

**If using an Updated 4L60E Reaction Shaft, Soak the Torrington in ATF, Stick the bearing to the Reaction Shaft......The Delco Shell kit comes with a Shell, Shell to reaction shaft Torrington bearing, Reaction Shaft, & Input planet to reaction shaft Torrington bearing.

**If you are using a Beast or Sonnax Shell, You can still "rollerize" the Reaction Shaft, You need a Reaction Shaft & BOTH Torrington bearings from GM.
**NOTE** DO NOT use the Input Planet to Reaction Shaft Torrington from the bearing kit if you get a Reaction Shaft from GM, It was revised in '07/'08.
Attached Images
  
clinebarger is offline   Reply With Quote