^^^ This is the mess that is my dash.
^^^ This is the chunk of aluminum they used to cover it up.
^^^ Here is the mount for my fuse panel, with legs to allow me to run wires underneath for the harness.
^^^ And here we are, welded in place to the right rear cab wall. The piece of aluminum was used to keep the tabs in proper orientation while they were welded to the back cab wall. It is the same size as the fuse panel, so I can either leave it be, or remove it when I mount the panel on the tabs.
I did not get much done today thanks to extra honey do's, but any progress is good progress.
-Joe