[sprint_9]

Took a day off work today, got the front floor support cut out and tacked in, rear floor support mostly fitted, outer floor ready to weld in. From there I hung my door and got it aligned, atleast the best that I can get with what I have to work with. Everything is pretty good with the exception of the top corner where the vent window would be, that gap is pretty narrow and widens as it goes lower down the angle of the windshield pillar, everywhere else on the door is a pretty even gap.

Once I got a fairly satisfactory gap I worked on some loose mock up of my outer rocker and cab corner. Rocker doesnt fit too bad, I need to go toward the fender some or maybe add a little filler piece. Cab corner is terrible. I have two different sets of cab corners and both are garbage. Im going to cut one up tomorrow and see if I can get it bent around to fit, its definitely going to be a challenge.