View Single Post
Old 06-23-2014, 08:57 PM   #54
sockalaminski
Registered User
 
Join Date: Feb 2013
Location: Phoenix AZ
Posts: 88
Re: Attempting my first build 72 K5

Quote:
Originally Posted by 72K5CSTDarkOlive View Post
I realized I asked a dumb question.. My real question is. When I dissembled the front axle, did I remove the axle shaft bearings? (the only thing I didn't take apart was the differential plate and ring & pinion)
You need the inner and outer bearings (the tapered ones) and the axle bearing,(needle bearing). The needle bearing is pressed into the spindle. When you look inside the spindle on the side where the bolt flange is, you will see that needle bearing

Last edited by sockalaminski; 06-23-2014 at 09:08 PM.
sockalaminski is offline   Reply With Quote