[solidaxel]

I had the same problem with my 55 1st series, but it was only in spots at the top of the door with new inside and outside w/strip.
I located the two spots that were not hitting the cab and they were in the area of the division bar. I removed the glass and vent glass held the door open with a 2x4 and proceeded to BEND the top of the door frame in the area that was in question. Replaced the glass and removed all the extra weatherstripping and now everything fits and seals. Try closing a paper shop towle between the door and cab in various places and see if you can remove it. this will tell you where it is high and low, bend to fit without the glass. It worked for me