The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

tmoble · 03-10-2011, 05:14 AM

You, anybody home?

Looks like I might be going with this setup. Anybody know the correct angle of the dangle on the mounts for the trailing arms? 15 - 20°??

Using the stock frame, no Z, any issues getting the center section under the bed?

Coronas56, what are you doing about the torque arm? I think I want to run it, that crossmember I see in the photos of the Flat Out Engineering stuff looks like it's too close to the centerline of the axles, probably end up getting bent if any power was put to the ground.

03-10-2011, 05:14 AM	#107
tmoble Registered User Join Date: Feb 2009 Location: Glendale, Az Posts: 1,062	Re: Change of plans You, anybody home? Looks like I might be going with this setup. Anybody know the correct angle of the dangle on the mounts for the trailing arms? 15 - 20°?? Using the stock frame, no Z, any issues getting the center section under the bed? Coronas56, what are you doing about the torque arm? I think I want to run it, that crossmember I see in the photos of the Flat Out Engineering stuff looks like it's too close to the centerline of the axles, probably end up getting bent if any power was put to the ground.