The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

forestb · 06-01-2018, 11:22 AM

mine is not raised

The angle strips on the side of the inside of the bed should not be sitting on the cross braces. There should be about a 3/4 inch space between those angles and the cross braces that run vertical under the bed there should be wood in between them. You can kind of see what I am talking about in this photo. If there is not enough wood there the bed will be to low

06-01-2018, 11:22 AM	#12
forestb Registered User Join Date: Jan 2009 Location: Burbank, CA Posts: 3,584	Re: Fitting Bed Wood mine is not raised The angle strips on the side of the inside of the bed should not be sitting on the cross braces. There should be about a 3/4 inch space between those angles and the cross braces that run vertical under the bed there should be wood in between them. You can kind of see what I am talking about in this photo. If there is not enough wood there the bed will be to low Last edited by forestb; 06-01-2018 at 11:30 AM.