So unloomed and depinned this bad boy about 6+ months back.
Now looking to finish it off and get it into they truck.
Whats the best approach here ? Stuff like ....
Routing and lengthening/shortening wires ..... which ones typically ..... injectors seem to be a standout as they are in completely different positions. eg first part of harness from the PCM .... .annd then about smack bang in middle of the middle run.
Grounds - how many should there be ? Where do they connect (Harness was removed by a friend whilst I was dissaembling the trans).
Other suggestions ?
This a 2007 lq4 6.0.