The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**l79m20** · 08-01-2013, 08:48 PM

So i bought a lift for my 76 3/4 ton. Everything went on fine. Front lift springs, rear blocks, rear extended brake hose. Then I get to the front hoses. They wont fit. They are the right length, but the banjo bolt for the caliper is too big to go through the new fitting. I went to autozone and had them pull me a replacement caliper and hose to verify that mine were correct. Turns out they are and the stock hose has a larger opening then the one from Rough Country. I call rough country and they dont know what happened. Maybe a faulty hose build. So they send me new ones and they still dont fit. I am %100 sure its a dana 44. Im %90 sure that they are stock correct axles front and back. I just dont know why they dont fit. Does anyone have any suggestions???? Any other problems like this from Rough Country?

08-01-2013, 08:48 PM	#1
l79m20 Registered User Join Date: May 2005 Location: Reading, Kansas Posts: 628	Rough Country Lift So i bought a lift for my 76 3/4 ton. Everything went on fine. Front lift springs, rear blocks, rear extended brake hose. Then I get to the front hoses. They wont fit. They are the right length, but the banjo bolt for the caliper is too big to go through the new fitting. I went to autozone and had them pull me a replacement caliper and hose to verify that mine were correct. Turns out they are and the stock hose has a larger opening then the one from Rough Country. I call rough country and they dont know what happened. Maybe a faulty hose build. So they send me new ones and they still dont fit. I am %100 sure its a dana 44. Im %90 sure that they are stock correct axles front and back. I just dont know why they dont fit. Does anyone have any suggestions???? Any other problems like this from Rough Country?