[jonmc56]

One of the first projects was to rework the wiring. One of the main powerup wires from the battery to the bulkhead connector ran across the core support, and there was a brittle and corroded wire in that segment. One thing led to another, and eventually I had all the underhood wiring apart. A lot of the wiring was new, expect for the core support wire that started me on this project. I'm a big fan of the wiring recommendations that Mark makes at MAD Electrical, so I took the opportunity to make some changes. I put a new junction block at each of the four corners of the engine compartment, and ran the alternator output directly to the new junction block next to the bulkhead connector. I also bought a bunch of braided wire loom from Waytek, and wrapped everything. I took the opportunity to draw a new diagram so that I could remember what goes where.