Quote:
Originally Posted by 67c10rustbuket
no prob, I measured mine and the spot weld is 1" from the bottom of the bottom hinge hole. I just guessed that dimple was it that i circled yellow. It looks like it should be a little higher. Later, gotta Mow and write some essays then on to my truck this eve!
|
You were pretty much right on the money. I had cut just a pinch below that dimple, so I am okay. Unfortunately, I did not cut the straightest line in the world, but I will smooth it out with a grinder.
Got the piece off. I do have the reinforcements, although it's attached by a spot weld, which I need to work on breaking off. My outer floor and rear pillar (which I might not be using based on your advice) should be here on Tuesday.
Looking forward to finally getting some progress by next weekend!