|
Re: Hydraulic Clutch Conversion 1965C10
Hey guys, a few questions...
I was able to mimic the clutch pedal linkage which was awesome, but since I am using a lt1 t56 with a 1 pc rear main seal, I'm going with full lt1 factory hydraulics, clutch, flywheel, everything...
I used a stock slave from a 91 z28, which is the same as a 97 lt1 that my trans came from but with an additional bleed screw in the slave. I bled and bled this thing, but the clutch doesn't disengage enough for me to put the truck into gear...
The clutch is actuating, just not far enough. Does this master just not move enough fluid? Not enough stroke? Any ideas on what I might be doing wrong? Thanks in advance guys.
__________________
"We must reject the idea that every time a law is broken, society is guilty rather than the lawbreaker. It is time to restore the American precept that each individual is accountable for his actions." Ronald Reagan
|