hey dsraven thanks for the links you posted.you are a great asset to this forum giving out lots of great help and insight. MARTINSR is one who posted link about gage and how to use it props to him for that! trammel/tram gage was easy to build 1/2" electrical conduit an old steel broom handle was good enough diameter to use to cut up for section that needs to slide. 3/8" dia round stock for pointer. I had to adjust mig welder as broom handle tubing is thin wall. hey
mr48chev i have full length bbc headers so not going super low. i have small computer in garage so i now have a 32" frame blueprint/frame drawing on the screen to look at thanks for pic. some of the body mounts and their rivet areas seem to be some good checking points. also back rivet on rear axle bump stop bracket is a reference spot for checking axle centerline.
