The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Building a Custom GMC Dash Bezel from the ground up :).

siggyfreud · 08-13-2015, 01:16 AM

A night of great progress

Didn't get started until around 8pm or so tonight, but made some great progress on this project. I picked up some 1" insulation foam at the hardware store to do a test run of the design. Worked great. After it was cut I compared it to the original. Very close in size, but not there yet.

I made a rookie mistake. When I drew the profile line of the design, I think moved OUTWARD from that line for the trim ring, rather than inward. As such, my design is too big by exactly the size of the trim ring. I need to swap the trim ring to be on the inside, and it should be nearly an exact fit.

I also didn't mill the inside as deep as the final design to save on cutting time, since I'm primarily concerned with outside size fit at the moment. Will try again in the new few days and then test fit. I also used a 1/4" bit for the entire thing, so some of the rings couldn't be fully cut due to the distance being less than 1/4" between pieces inside. But for now, some eye candy:

08-13-2015, 01:16 AM	#20
siggyfreud Registered User Join Date: Jun 2012 Location: Portland Posts: 1,330	Re: Building a Custom GMC Dash Bezel from the ground up :). A night of great progress Didn't get started until around 8pm or so tonight, but made some great progress on this project. I picked up some 1" insulation foam at the hardware store to do a test run of the design. Worked great. After it was cut I compared it to the original. Very close in size, but not there yet. I made a rookie mistake. When I drew the profile line of the design, I think moved OUTWARD from that line for the trim ring, rather than inward. As such, my design is too big by exactly the size of the trim ring. I need to swap the trim ring to be on the inside, and it should be nearly an exact fit. I also didn't mill the inside as deep as the final design to save on cutting time, since I'm primarily concerned with outside size fit at the moment. Will try again in the new few days and then test fit. I also used a 1/4" bit for the entire thing, so some of the rings couldn't be fully cut due to the distance being less than 1/4" between pieces inside. But for now, some eye candy: __________________ Current Build - Project "Ghost of Poseidon" 72 C10 Pro-touring build Previous Build - 66 GMC Pro-touring build. Sold.