[oldman3]

Hey everyone. Nothing special here, but I've been asked a few times about my horses I used to do body work, primer, paint, and buffing. I thought it would be best to do a small thread that I can give people, wether than answering each time. So here goes.

The first 5 pics are of the horses that have been used for about 20 yrs off and on different projects.

Pic 1, 2 and 3 show how the top board holds the fender in place. Holes were drilled to line up with holes in the fender. This distance may be different on each, so just clamp in place, mark and drill holes.

Pic 4 shows notch cut in upright for top board to be screwed too.

Pic 5 shows the cross floor section and how's it's notch on both boards and screwed together so it sits flat. Add braces as needed.