[Desert_Eagle02]

Well I finally have some time to start working on the truck. I picked up a rebuild kit, new floats, an Edelbrock spacer (on hot days when the engine is hot, it can be hard to start. I was told this should help quite a bit) and a new fuel filter. Looking over the carb before I take it off I notice the pcv fitting in the carb is capped off. I look at the valve covers and it has an oil breather on each side. I don't know why I never noticed this before.

So should I buy a valve and hook it up? Would the current setup make it run a bit richer, since it's not getting as much air as it would if it was installed?