[75Dually]

Had the stomach flu all week, Yuck! So today was the first day I felt decent. So this evening I got out to the shop and started to clean up the cross member. Once I got most of the grime off of it I mounted it to my fabrication table and mocked up the suspension.

I have got a good idea what I need to do for the bag fitment. The picture below of the bag in place is just me messing around when it got late in the evening. I will be of course modifying the lower a-arm, but I have some serious plans for the upper spring pocket as well. Most of it will be cut away. I want all the angles to be right so that I allow the bag to move in as straight a line as possible. I have seen to many builds where the air bag is pulled at odd angles, and this allows increased wear and potential failure.

So tomorrow should be a fun day in the shop. I hope to have the lower a-arm and the upper spring pocket at least roughed in. Then I am going to start finding the right spot for the air ride sensor. Stay tuned!