The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Fuel Tank Selector Valve mounting bolt size

Nickelcharlie · 11-19-2018, 10:32 PM

I just finished doing mine and this is the wrench, I used, a 1/2 Snap On. Finally found something I could use this wrench on! The only wrench that I had that I could get in there with. The bolts are a PIA to remove! I also had the bed off. I have done it both ways bed on and bed off and for me it is much easier with the bed off.

With this wrench it didn't take but just a few minutes to remove the bolts. Replacing the valve I got my wife to start the bolts on top while I held the valve from the bottom. Works fairly easy this way.

11-19-2018, 10:32 PM	#4
Nickelcharlie Registered User Join Date: Sep 2016 Location: Cleburne, Texas Posts: 75	Re: Fuel Tank Selector Valve mounting bolt size I just finished doing mine and this is the wrench, I used, a 1/2 Snap On. Finally found something I could use this wrench on! The only wrench that I had that I could get in there with. The bolts are a PIA to remove! I also had the bed off. I have done it both ways bed on and bed off and for me it is much easier with the bed off. With this wrench it didn't take but just a few minutes to remove the bolts. Replacing the valve I got my wife to start the bolts on top while I held the valve from the bottom. Works fairly easy this way. Attached Images Last edited by Nickelcharlie; 11-20-2018 at 03:11 PM.