|
What are you guys using for a shifter with the overdrive conversion. Obviously the original column shifter is only 1-2-3-n-r-p, so one more detent is needed (unless you are willing to lose 1st gear selection). Is there an oem/junk yard solution for column change/conversion?
I pulled a 200 4R from the junkyard and installed it using the stock column linkage on my 71 Cheyenne 20, but lost 1st gear selection. The change was very easy apart from the shifter issue. I ended up pulling the tranny out and putting the TH350 back in because the 200 needs a rebuild.
But after I rebuild it, what can I do for proper shifter selection?
(BTW, I did several searches and the only answer I could find was to use an aftermarket column/shifer...$$$$)
Thanks,
Tim
|