[72K5CSTDarkOlive]

I ordered a complete new set of lower side panels through Mar-K. With the steering wheel and door panels redone using the rosewood 3m di noc, I just felt that it would look off with the original wood grain used on the lower side panels so I decided to change them all to match.

The 3M Di Noc rosewood grain start out at 4' wide x 1' length and the grain runs length wise not width,

In order to have the grain run the length of the tail gate band and lower panels, I had to order a 4'X7'... Let just say I have enough left over to do 2-3 more of these lol