[JasonWynn88]

I picked up a set of 65 camel humps casting # 3782461 putting them on 1965 C10 Have a few questions about the install

1. How will they work as far as compression wise they are going on my 72 350block with 75cc heads what will the compression be? Will i have to use 2 head gaskets?

2. Will a 4 barrell in take off of a 85 chevy c10 i believe it is a factory 4 barrell will it work and accept a edelbrock carb. Trying to figure out where i will need to hook up temperature sending unit since the camel humps dont have a port for that.

3. Wanting to put a new cam in it also what cam do i need to look for that will work correctly with the camel humps. Just want something a little more aggressive than stock.

4. How hard is it to swap the alternator to the driver side i know i have to swap water pumps to a short one also.




Any Help would be apperciated



THANKS
Jason