Re: budget beater c10 to k30 swap over build.
little rear bumper action today .
made my brackets to the frame with 2 - 5/8" holes & 2 - 1/2" holes each . this should hold here on there good-n-tight ! 1st pic i still have yet to do the 4th hole . the other 2 holes clear the factory cross member rivet's . and the brackets are just 3.5"x3.5"x1/4" wall angle . . .
then test hung the main section of the bumper to make sure depth was good and tailgate thats BENT clears when down . then i marked were to cut the bumper to let the brackets pass threw for final weld both sides .
__________________
77-k30lb BIG truck build .
87-k30lb budget beater build .
85-k30lb the plow machine build .
85-c10sb summer fun toy .
-----------------------------
HOLLEY SNIPER efi = worst case of p.i.t.a i ever had .
EDELBROCK pro flo 4 = best deal going so far . love my setup works great.
|