[Orange Crate]

Some progress. Got all my Timken bearings and the gasket kit installed. I have a 1350 yoke for the rear output but I still have the old stock CV and drive shaft for the front. I upgraded the front output to a 32 spline so I'll have to make a decision on what I want to do for a front drive shaft. Any suggestions? I was thinking of going with a flat flange output and then a flat 1350 bolt on yoke. The truck has a 2" lift with a D60. I would like to have all 1350 u-joints in the drive train. Damn this thing is heavy, had to use the overhead hoist to get it bolted to the NV4500.... I have a case of high temp silver paint so.....