Re: Blank METAL instrument bezel??
I would say no, I thought about this years ago when trying to decide on a custom gage board.
I would recommend you take the plastic one to Chesapeake Bay Rubber and Gasket in Norfolk off of Princess Anne and see if they can cut one on the Flowjet machine as per your sample. They cut all kinds of patterns in sheet metal, acrylic sheets and plexiglass etc..
https://www.cbrg.net/
__________________
Mike
72 C-10 Cheyenne off frame resto and Upgraded to 4 wheel disk, Tilt, Dakota Digital Dash / Rear slider.
421 SBC / TH350 3000RPM Stall
Progression Ignition /Holley 750 DP/3:73 gear Eaton Limited Slip unit / 2 1/2 exhaust glasspacks
|