View Single Post
Old 12-24-2012, 10:53 AM   #3
Realnoisy
Registered User
 
Realnoisy's Avatar
 
Join Date: Dec 2011
Location: Houston, Texas
Posts: 229
Re: Shortening Control Arms for Narrowing Track

Quote:
Originally Posted by SCOTI View Post
I know about sectioning the lowers to pull them in but not the uppers (typically narrowing the lowers requires fewer shims for the uppers thus pulling them in).

Mine had the lower BJ cut out as a square section, removed the amount of material that the BJ needed to be moved inboard, & then re-welded together. The bump-stop is removed of course & the a-arm lip is trimmed significantly.
Scoti, any mods to the tie-rod ends after doing this?
Realnoisy is offline   Reply With Quote