The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

6T7 C10 · 12-31-2017, 04:30 PM

For whatever it is worth I did my first GM 12 bolt truck this summer and changed all the bearings, seals, ring 3.73, pinion, and added a Truetrac. So far it has been silent, running cool, and everything works so far. I think it looks just slightly too deep as well. Your backlash measurement is very good but when you change any of the shims on the carrier or pinion it all goes back out the window to try again. I had to fit and refit mine many times to get it the best I could in all directions with the shim set I had. I don't remember using so much on the pinion. I recall mine was around .026-.028 but each one is an individual and yours will vary. I admire your efforts, best of luck to you and you are getting close.

12-31-2017, 04:30 PM	#6
6T7 C10 Registered User Join Date: Feb 2015 Location: TX Hill Country Posts: 150	Re: Check my gear pattern :) For whatever it is worth I did my first GM 12 bolt truck this summer and changed all the bearings, seals, ring 3.73, pinion, and added a Truetrac. So far it has been silent, running cool, and everything works so far. I think it looks just slightly too deep as well. Your backlash measurement is very good but when you change any of the shims on the carrier or pinion it all goes back out the window to try again. I had to fit and refit mine many times to get it the best I could in all directions with the shim set I had. I don't remember using so much on the pinion. I recall mine was around .026-.028 but each one is an individual and yours will vary. I admire your efforts, best of luck to you and you are getting close.