The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 47-55.1 Not as low IFS

whitedog76 · 11-07-2018, 05:00 PM

Since I welded 1.25" on the crossmember, I'll need to trim that much off the top hats. That's the sharpie mark you see
I have some 1/4" plate that I'm going to make some gussets out of. I'm also going to make a brace for the lower control arm tube.

11-07-2018, 05:00 PM	#5
whitedog76 Registered User Join Date: Jan 2014 Location: Peoria, IL Posts: 1,450	Re: Not as low IFS Since I welded 1.25" on the crossmember, I'll need to trim that much off the top hats. That's the sharpie mark you see I have some 1/4" plate that I'm going to make some gussets out of. I'm also going to make a brace for the lower control arm tube.