The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**'68OrangeSunshine** · 04-20-2017, 01:07 AM

Also held the stock vacuum line wrapping around from the alternator on the passenger side to the carb on the drivers side. I think it was aluminum 1/8'' tubing. Possibly even the stock steel 5/16'' fuel line, if I can remember that far back.
The wires from the bulkhead connector to the Coil and Alternator were clipped on the passenger side. [Plus water temp gauge line and elec oil pressure idiot light.]
If your oil pressure warning light went on -- it meant you were screwed.

04-20-2017, 01:07 AM	#3
'68OrangeSunshine Senior Member Join Date: Feb 2002 Location: Tucson, AZ USA Posts: 7,029	Re: 250 valve cover clips Also held the stock vacuum line wrapping around from the alternator on the passenger side to the carb on the drivers side. I think it was aluminum 1/8'' tubing. Possibly even the stock steel 5/16'' fuel line, if I can remember that far back. The wires from the bulkhead connector to the Coil and Alternator were clipped on the passenger side. [Plus water temp gauge line and elec oil pressure idiot light.] If your oil pressure warning light went on -- it meant you were screwed. __________________ Every 25 years I like to rebuild that 292, whether it needs it or not.