The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Beatrice · 01-09-2018, 11:10 AM

yes perfect. that's what I was hoping to do. my plan was to use the front two sills and rear. mount those to frame and then put .75 square or round stock for spacers (where wood was) then once that's all squared to the cab and good to go I can then start welding my 1''x1'' square like your picture. Only difference is I'm doing a tilt bed floor between the wheel wells so mine top will be setup different. i'm going to put my spacers above the cross sills so I don't have to change the spacing on the inner bedsides itself.

thanks for your help I was hoping it would work out like that.

01-09-2018, 11:10 AM	#7
Beatrice Registered User Join Date: Dec 2017 Location: Ohio Posts: 36	Re: raised bed floor question bagged truck yes perfect. that's what I was hoping to do. my plan was to use the front two sills and rear. mount those to frame and then put .75 square or round stock for spacers (where wood was) then once that's all squared to the cab and good to go I can then start welding my 1''x1'' square like your picture. Only difference is I'm doing a tilt bed floor between the wheel wells so mine top will be setup different. i'm going to put my spacers above the cross sills so I don't have to change the spacing on the inner bedsides itself. thanks for your help I was hoping it would work out like that. Last edited by Beatrice; 01-09-2018 at 11:53 AM.