|
Re: '78 K20 to C10. Almost 20 years in the making.
Nice job on the exhaust system fab! Glad to see you used sections of mandrel bends. I made my own head pipes using mandrel bends when my truck had 96-up cast iron manifolds. The welds weren't quite as nice as yours though.
Ended up doing it again after installing high-tuck headers.
Man, I hate that crossmember, which is high on one side, low on the other. May someday get this one: https://www.ifabspeed.com/product-pa...e-dd9b12240478
__________________
Mike
1969 C10 LWB -- owned for 34 years. 350/TH350, 3.08 posi, 1st Gen Vintage Air, AAW wiring harness, 5-lug conversion, 1985 spindles and brakes.
1982 C10 SWB -- sold
1981 C10 Silverado LWB -- sold, but wish I still had it!
1969 C10 (not the current one) that I bought in the early 1980s. Paid $1200; sold for $1500 a few years later. Just a hint at the appreciation that was coming.
Retired as a factory automation products salesman.
Worked part-time over the years for an engine builder and a classic car repair shop.
Member here for 23 years! This is the very first car/truck Internet forum I joined. I still used a dial-up modem back then!
|