View Single Post
Old 04-28-2012, 10:37 PM   #1
Daddy Brim
Senior Member
Daddy Brim's Avatar
Join Date: Feb 2011
Location: Clovis Ca.
Posts: 633
Resetting a 67 distribution block ?

I have 67 C-20 a while ago I had front brake failure, broke rubber line. since then I have replaced all rubber lines, calipers, shoes, and springs. I'm trying to bleed the system and it appears that I have all of the air out, not seeing any air bubbles when I open the bleeder. It appears the amount of fluid coming out the back is more than the front. There is no brake peddle, and I wound doubt it is the master cylinder as everything was fine before brake line broke. I have tried to do some research some say the distribution block needs to be reset others there is nothing to reset. What do I need to do to fix these brakes? I'm at my wits end. This is the distribution block that is in my truck.
Attached Images
I'm sorry I called you stupid. I thought you knew already.

67 C-20 Custom Camper
68 Nova 396 it does wheelies
2005 Buick Century the one the wife drives
1989 Toyota Tercel to drive when I can't put gas in the first 2.

Last edited by Daddy Brim; 04-29-2012 at 08:45 AM.
Daddy Brim is offline   Reply With Quote