View Single Post
Old 01-31-2017, 08:58 PM   #1
76stepsidechevy
Registered User
 
Join Date: Nov 2010
Location: Windsor Locks
Posts: 628
Thinking of lowering my 2000 silverado 1500 4wd

So long story short everything I've owned in the past 12 years has been lifted so I'm thinking of going the other way. The truck is a 2000 z71 and has 3" blocks in back (in place of factory 2" blocks) and torsion bars cranked all the way up by previous owner. Obviously I can pull the block and be 3" lower out back but what about the front? Can I "decrank" the bars that much? I'm guessing they gained about 2 inches by cranking them all the way up. I'm not looking to go crazy low here as I still intend to use this as a truck. Just looking for some advice here on a good budget friendly and safe setup. I'm planning on running a set of tahoe ltz 20s with some 275/60/20 tires.
76stepsidechevy is offline   Reply With Quote