View Single Post
Old 07-02-2006, 08:16 AM   #6
mbgmike
Registered User
 
Join Date: Aug 2005
Location: Pasadena,Tx /Pto Pta DR
Posts: 5,415
Re: how to remove the oil pickup tube from the oil pump?

Quote:
Originally Posted by glock35ipsc
I agree with cdowns. Pickups are fairly cheap. Push in the new one, or the old one if you are going to reuse it. The, install the pump, set the gasket inplace and set the pan on to adjust the gap. Then tack weld in place. I always tack weld them on if I use the old one again.
I agree also . They make a tool to remove it. On the cheap you can use a open end wrench with a hammer (if your careful). But as said above., use a new one and tack it on.
mbgmike is offline   Reply With Quote