[520-k5]

I've read just about all the threads online that I could find. After alot of speculation on measuring 6" back from the rear cab mount it put the line right on the rear edge of the front bed bolt hole so we decided to mark 7" back and start there.then we measured 14" back and layed out our lines. We did a z cut method with 7" on each side of the z and a 4" height on each as the frames 8" tall. We used 3 cutting methods started out with the plasma cutter until the tip burnt out and being late at night and no replacement we decided to finish with a 41/2" cutoff wheel and a sawzall. Gotta thank one of my best friends ed port for setting time aside in his busy schedule to let me use his shop as well as help me out with this project.