[CousinTone]

Now you’re ready to line everything up for mounting and mark the adapter plate for the two bolts (the sector is pictured here and the face you see will be in the “meat” part of this sandwich) that will hold it to the motor & regulator assembly.

As you will see, two holes need to be drilled as Steve points out and again I used the 13/64th drill bit. These turn out to be “blind” or real hard to get to!! Here’s where I reversed Steve’s process and placed “10x1” machine screws on the inside of the attachment plate and spot welded them in place. Depending on your welding skill, you may need to grind down the size of your spots to clear the small are they are now at home. One way to hold them is to bolt them in place and then spot weld them then remove the bolts. This will ensure they’re straight and will mate with everything else.