[BIGglaSS]

Originally Posted by DLW

More noob questions.

Since it looks like I will go the bridged route with passive crossovers, do I still use the HPF and LPF on the amp for anything, just SUB?
SUB only.

Set channel mode = Bridged
Level = all the way down until ready to tune?
HPF?
LPF?
Set for "Full" or "HPF"?
Bridged, FULL. Turn the levels all the way down. In bridged mode you are sending a lot of power to the speakers.

Sub woofer, top row:

• Source = Ext.
• Level = low to start?
• Subsoninc = ? Woofer has a range from 20 - 250 Hz, so put it lowest? Sub has a slot-ported enclosure if that matters.
• Set to LPF?
• LPF = 80 Hz?

Yes. Ported subs should use a subsonic filter. Start at the highest setting.


Rear is not used in bridged mode right?
Check the wiring diagram in the owners manual. It uses a combo of front and rear, L/R

I also don't need to run rear pre-amp cables from HU to amp?
Nope

Hope this helps...